Electrical Safety

Tips In Troubleshooting Home Electrical Issues


Professional electricians are sought after for their electrical fault finding capabilities. Using their knowledge, training, and experience, they can identify, narrow down, and resolve electrical issues in the most efficient and safest way possible. This is the very reason why electrical works are not for everyone.

If you are a DIYer, you’ll need to look the other way when it comes to electrical projects. Unlike most traditional DIY projects, electrical works involve serious risks that it is always best to leave the job to the professionals.

While electrical repairs and other electrically-related tasks will need to be taken care of by a qualified technician, homeowners may still be able to identify or isolate and troubleshoot small and basic electrical problems. In this article, let us tackle a few of them.

Identifying Home Electrical Wiring Failures and Electrical Problems

At some point, we all have experienced a power failure. When this happens, the first thing a homeowner can do is determine whether the issue lies in the home’s system or is due to the utility company outage. If the whole house is out and it looks like your neighbors have the same problem too, you’ll know the problem is not within your home wiring system, and you may contact the utility company for further details.

However, if any of your home’s electrical power works — for instance, lights or outlets in another room — the issue is with your system. The problem is may be caused by an overloaded circuit, a short circuit, or loose wiring.

If the issue happened when someone was using an electric heater, hair blower, or some other appliances that draw a lot of electricity, the problem is probably due to a circuit overload. If the circuit is overloaded, this can cause a circuit breaker to trip.

If the troubled circuit has a GFCI or Ground-fault circuit interrupter outlet or circuit breaker, typically you can solve the problem by just pushing the reset button. If not, you can check the subpanel or main panel that powers the circuit. Unplug or turn off everything from the non-working circuit.

Afterward, reset the circuit breaker (here’s a handy video on how to reset the circuit breaker). If the circuit blows immediately, there is likely a defective component or charred wire in the circuit that needs a replacement. If it doesn’t blow off, turn the lights back on and plug in your devices one by one to check for the short circuit or overload. If the problem happens again when you plug in the device that draws a lot of current then your circuit is overloaded, and it’s high time you have your electrical service upgraded. If the lights or outlets still do not work, there is likely a loose wire somewhere in the system.

In either case, you will need to contact a qualified electrician promptly to resolve the issue, especially if you notice charred wires in the panel, I trust Columbus Ohio Electrician – www.electriciancolumbusohio.com do to the job for my home and can recommend their service to anyone.

When attempting to identify and troubleshoot the problem, be sure that the power from the main source is turned off. You can use a tester to double check whether or not there is still an electric current flow to the outlet or switch. Never work on an electrical project with wet hands and don’t stand in wet surfaces or damp floors even if you think you are just working on low-voltage wiring including telephone wires.

For your safety, doing your own electrical repair is strongly discouraged, unless you are experienced and knowledgeable about electrical jobs. If you feel confident with your skills, be sure to follow all electrical safety precautions. It’s even better if you don’t take chances and contact a professional electrician to take care of the problem at once.